Things that need changing on FT-450d immediately after factory reset:
- SQL/RFG -> RF GAIN
- PNL-C.S -> SWR
- SELDIAL -> RFPOWER
- P M-FST -> VM1TX
- P M-UP -> VM1REC
- Step -> 1 (step/split button, not menu)
- Add GB3FX – 50.81 tx, 51.31 rx (+0.5MHz offset), 82.5Hz tone
to be updated as I recover from a factory reset 🙁
I appreciate you putting this information on here, but for some reason I was unable to get to the step Dash greater than symbol one it says it’s not menu do I exit out of the menu to change that?
Not sure I understand the question, sorry.